Riveter & Nutter HR30N
This single caulking tool can both caulk and lock nuts.
[Features]
· Enables drilling of the base material to be welded and the part, even if one side of the base material is sealed.
· Can join by setting a blind rivet to the hand riveter and squeezing.
[Applications]
· Tightens parts and base materials and creates nut holes (screw holes) in materials such as thin sheets.
[Features]
· Enables drilling of the base material to be welded and the part, even if one side of the base material is sealed.
· Can join by setting a blind rivet to the hand riveter and squeezing.
[Applications]
· Tightens parts and base materials and creates nut holes (screw holes) in materials such as thin sheets.
(i)Remark
- Cannot be used with 4.8 mm stainless steel rivets.
- If the shaft is not cut, grasp the handle again. After caulking, open the handle up widely and take out the shaft. Lubricate the joint part of the handle from time to time. Remove and clean the jaw from time to time. (Riveter only).
Part Number
Once your search is narrowed to one product,
the corresponding part number is displayed here.
HR30N
Basic information
| Product Category | Riveter & Nutter | Compatible Rivet Size | 4 / 2.4 / 3.2 / 4.8 | Compatible Nut Size | M4×P0.7 / M5×P0.8 |
|---|---|---|---|---|---|
| Weight(g) | 720 |
This page is Riveter & Nutter HR30N, part number HR30N.
You can find the detail information about specifications and dimensions on part number HR30N.
- The specifications and dimensions of some parts may not be fully covered. For exact details, refer to manufacturer catalogs .
Tech Support
Payment Method
On-Demand Manufacturing
Certificates
Copyright © MISUMI Corporation All Rights Reserved.