GANTER Handles / Bow handles / Cup handles / Trough handles / Carrying handles（Main Body Material：Stainless Steel (Deleted)）

Stainless Steel-Cabinet "U" handles GN 425 Ø 6, Ø 8 and Ø 10 are supplied with two stainless steel location discs. They guarantee a perfect location even with large holes in the cabinet. The discs are loosely enclosed.The manufacturing process (bending) allows the production of special lengths in relatively small quantities.

GN 425.9 Stainless Steel-Folding handles are used where the handle must only protrude a short distance in the resting position.Folding handles numbers 1 and 2 are suitable for side “access,” as these have a 90° limit stop. If used from above, numbers 3 and 4 with a handle which can fold freely through 180° are a better version.The retaining springs of numbers 2 and 4 keep the handle in any position. This keeps the handle in a position which can be easily accessed and prevents noise as a result of vibration in the resting position.The handle and the retaining springs are secured by mounting the attachment across the entire surface. All components are supplied unassembled.

Stainless Steel-Cabinet "U" handles GN 425 Ø 8 and Ø10 are supplied with two stainless steel location discs. They guarantee a perfect location even with large holes in the cabinet. The discs are loosely enclosed.The stainless steel design version should be given preference.

The manufacturing process (bending) of the Stainless Steel-Cabinet "U" handles GN 425.3 allows the production of special lengths in relatively small quantities.

The GN 730.5 Stainless Steel-Ledge handle is used on doors, guards and hatches on machines, as well as on drawers and pull-out units.Due to the material used, the handle is intended especially for use in corrosive environments with aggressive media.The ledge handle is made in a way that does not allow pooling of fluids, which makes cleaning easier and prevents build up of residue and bacteria.It can be attached from the back side via the mounting thread. Alternatively, the handles can be welded from the front.

GN 429 cabinet „U“ handles are intended for use in hygiene areas. The sealed mounting surfaces enable fastening without dead spaces. The high quality finish prevents adherence of dirt and facilitates cleaning.The manufacturing process (bending) allows the production of special lengths in relatively small quantities.

Stainless Steel-Folding handles GN 425.2 are used in such applications where minimal protrusion is required.In both positions the handle is retained by a spring loaded detent.

Folding handles GN 425.5 are used in places where the handle must not protrude or protrude only a short distance. The handle is locked in place in the resting position by means of a spring-loaded (cup springs) thrust bolt. The static load capacity value given in the table is an approximate value which, if exceeded, may result in permanent deformation or fracture of the plastic attachment part. The folding handle GN 425.2 may be used as an alternative.